爆炸作用驱动液体抛撒初始阶段数值仿真

徐豫新; 王树山; 韩宝成; 刘永

doi:10.11858/gywlxb.2011.01.012

爆炸作用驱动液体抛撒初始阶段数值仿真

doi: 10.11858/gywlxb.2011.01.012

1.
北京理工大学爆炸科学与技术国家重点实验室，北京 100081；
2.
中国兵器工业规划研究院，北京 100053

详细信息

通讯作者:
王树山

计量
- 文章访问数: 7982
- HTML全文浏览量: 396
- PDF下载量: 718
出版历程
- 收稿日期: 2009-12-22
- 修回日期: 2010-04-06
- 发布日期: 2011-02-15

Numerical Simulation on Initial Stage of Liquid Dispersed under Explosion Drive

1.
State Key Laboratory of Explosion Science and Technology, Beijing Institute of Technology, Beijing 100081, China;
2.
Ordnance Industry Planning Project Institute of China, Beijing 100053, China

More Information

Corresponding author: WANG Shu-Shan

摘要

摘要: 针对灭火战斗部引战配合设计，研究爆炸作用驱动液体（水基灭火剂）抛撒初始阶段的特性。依据典型灭火战斗部的结构建立数值仿真模型，采用LS-DYNA软件进行仿真计算，分别获得了加载系数（驱动装药与液体的质量比）对壳体破裂时间和壳体破裂初期液体/空气界面运动速度的影响规律，以及液体/空气界面后续的运动特性。进行了同条件下爆炸驱动水基灭火剂抛撒实验，得到了不同加载系数条件下壳体破裂初期液体/空气界面的运动速度。实验结果与数值仿真结果吻合良好，表明所采用的数值仿真方法具有正确性和有效性，对相关问题的研究具有重要参考价值。
- 爆炸力学 /
- 水基灭火剂 /
- 爆炸驱动抛撒 /
- 数值仿真
Abstract: For fuze-warhead cooperation design on fire extinguishing warhead, characteristics on liquid (based-water extinguisher) dispersed under explosion drive were studied. The numerical simulation model was built based on representative fire extinguishing warhead structure. The numerical simulation was done by LS-DYNA program. The influence rule about loading coefficient (drive charge divide liquid mass) to the breach time on shell, the movement speed on liquid/air interface at the shell breach initial phase, and the movement characteristic on liquid-air interface after shell breach were obtained. With the same simulation condition, the experiment on basedwater extinguisher dispersed under explosion drive was done. For different loading coefficients, the liquid/air interface movement speed at shell breach initial phase was gained. The results between experiment and numerical simulation were in good agreement, which indicates that the numerical simulation method was correct and effective. The research outcomes may provide important reference to investigate the relevant problem.
- explosion mechanics /
- based-water extinguisher /
- explosion drive dispersed /
- numerical simulation

HTML全文

参考文献(10)

Samirant M. Dynamic Measurements in Combustible and Detonable Aerosols [J]. Propellants, Explosives, Pyrotechnics, 1989, 14: 47-56.

Zabelka R J, Smith L H. Explosively Dispersed Liquid [R]. AD-863268, 1969.

Gardner D R. Near-Field Dispersal Modeling for Liquid Fuel-Air-Explosive [R]. SAND 90-0686, 1990.

Ding J, Weng P F, Liu J C. A Numerical Study on Liquid Ring Motion and Fragmentation for the Initial Process of Liquid Explosive Dispersal [J]. Journal of Hydrodynamics(Ser A), 2004, 19(2): 19-224. (in Chinese)

丁珏, 翁培奋, 刘家骢. 液体爆炸抛撒初期液环运动破碎的数值研究 [J]. 水动力学研究与进展(A辑), 2004, 19(2): 219-224.

Wang H Y. The Terminal Effects Research of the Fire-Extinguishing Warheads [D]. Beijing: Beijing Institute of Technology, 2007: 3-5. (in Chinese)

王海燕. 灭火战斗部终点效应研究 [D]. 北京: 北京理工大学, 2007: 3-5.

Glass M W. Far-Field Dispersal Modeling for Fuel-Air-Explosive Devices [R]. SAND 90-0582, 1990.

Ren X B, Lu X X, Li L, et al. Research on Experiment and Numerical Simulation of Explosion Drive Liquids Dispersed [A]//Proceedings of 9th National Conference on Shock Impact Dynamics [C]. Jiaozuo, 2009: 452-457. (in Chinese)

任晓冰, 陆晓霞, 李磊, 等. 爆炸驱动液体分散的实验与数值模拟研究 [A]//2009年第九届冲击动力学学术会议 [C]. 焦作, 2009: 452-457.

施引文献

资源附件(0)

访问统计